Repipe House

4 Signs That You Need to Repipe Your House in Myersville, MD

October 13, 2020

If one pipe breaks down, a plumber in Myersville, MD, can easily restore water flow by fixing or replacing the broken pipe. However, there are also situations when it’s best to replace every pipe in order to repair or optimize a plumbing system. Read on to learn four signs that indicate you need to repipe your house.

House is Old

A typical house that’s over 50 years old would benefit from repiping procedures if the pipes were never replaced. If you’re in this situation, you should arrange an appointment immediately because delaying this job could lead to plumbing problems down the road.

Most breakdowns happen in older homes that have galvanized pipes. When these pipes age, they usually corrode, and if a lot of pressure builds up in a corroded galvanized pipe, it’ll break.

Reduced Water Pressure

When water moves through a new plumbing system, it travels fast. As the pipes age, the water flow gradually slows down. However, you won’t notice this until you need to repipe your house.

Discolored Water Supply

If discolored water flows out of your faucets, you’ll need to replace all of the pipes. In this situation, replacing one pipe won’t restore the water quality. The water will continue to turn brown until after a plumber replaces every corroded pipe.

Many Leaky Pipes

There are two types of pipe leaks. Isolated pipe leaks are very common, so you’ll probably encounter them occasionally. Frequent pipe leaks aren’t common; these leaks occur when many pipes require a replacement.

Repiping is a project for a professional plumbing team. If you need to replace many pipes, contact Hagerstown Heating & Cooling to set up an appointment for our repiping service. During after-hour emergency repiping situations, we never charge an additional service fee.

Image provided by iStock

You May Also Like

4 Common Water Heater Issues in Clear Spring, MD

4 Common Water Heater Issues in Clear Spring, MD

Everyone experiences problems with their water heater at some point. Most problems result from the appliance's physical condition. These are the most common water heater issues you might encounter in Clear Spring, MD: Dirty Water Dirty water is harder to heat than...

Why is My Thermostat in Boonsboro, MD, Stuck in Recovery Mode?

Why is My Thermostat in Boonsboro, MD, Stuck in Recovery Mode?

Many homeowners have installed programmable thermostats that can reduce energy costs in Boonsboro, MD. Yet once you adjust its settings, the programmable thermostat may utilize recovery mode. When a thermostat is in recovery mode, it can quickly adjust the temperature...

Why Choose Us

shield icon

We offer 100 percent money back and ultimate buy back guarantees.

icon 24 hours

We are prompt, courteous, honest and answer all your questions.

percent icon

We wear shoe covers, use protective mats and clean the work area.

shield icon

Our super techs go through 90 hours of intense training every year.

handshake icon

We walk you through the entire process and provide upfront estimates.

  • This field is for validation purposes and should be left unchanged.

Pin It on Pinterest

Compliance Settings
Increase Font Size
Grayscale
Simplified Font
Underline Links
Highlight Links
Reset
Close